| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
iio: buffer: Fix DMA fence leak in iio_buffer_enqueue_dmabuf()
iio_buffer_enqueue_dmabuf() allocates a struct iio_dma_fence (104 bytes,
kmalloc-128) via kmalloc_obj()+dma_fence_init(), which sets the initial
kref to 1. It then calls dma_resv_add_fence() which takes a second
reference (kref=2), and stores a raw pointer in block->fence.
On the success path the function returns without calling dma_fence_put()
to release the initial reference, so every buffer enqueue permanently
leaks one kmalloc-128 allocation.
The iio_buffer_cleanup() work item only releases the temporary reference
taken during completion signalling by iio_buffer_signal_dmabuf_done();
the initial reference from dma_fence_init() is never released.
With four iio_rwdev instances at 240kHz and 512 samples per buffer,
this produces ~1875 kmalloc-128 allocations per second matching the
observed slab growth exactly. A test with ftrace confirmed that the
dma_fence_destroy event was never triggered.
Fix by calling dma_fence_put() after dma_resv_add_fence(), transferring
ownership of the fence to the DMA reservation object. The DMA fence then
gets properly discarded after being signalled. |
| In the Linux kernel, the following vulnerability has been resolved:
iio: gyro: itg3200: fix i2c read into the wrong stack location
itg3200_read_all_channels() takes `__be16 *buf' as a parameter and
fills the i2c_msg destination as `(char *)&buf'. Since `buf' is the
parameter (a pointer), `&buf' is the address of the local pointer
slot on the stack of itg3200_read_all_channels(), not the address
of the caller's scan buffer. The (char *) cast hides the type
mismatch.
i2c_transfer() therefore writes ITG3200_SCAN_ELEMENTS * sizeof(s16)
= 8 bytes into the parameter's stack slot, which is discarded when
the function returns. The caller's scan buffer in
itg3200_trigger_handler() is never written to, so
iio_push_to_buffers_with_timestamp() pushes uninitialised stack
contents to userspace via /dev/iio:deviceX every scan -- both a
functional bug (no actual gyroscope or temperature data is
delivered through the triggered buffer) and an information leak.
The non-buffered read_raw() path is unaffected: it goes through
itg3200_read_reg_s16() which uses `&out' on a local s16 value,
where that is correct.
Drop the spurious `&' so the i2c read writes into the caller's
buffer. |
| Improper authorization in Azure Portal allows an unauthorized attacker to disclose information over a network. |
| In the Linux kernel, the following vulnerability has been resolved:
net: mana: Add NULL guards in teardown path to prevent panic on attach failure
When queue allocation fails partway through, the error cleanup frees
and NULLs apc->tx_qp and apc->rxqs. Multiple teardown paths such as
mana_remove(), mana_change_mtu() recovery, and internal error handling
in mana_alloc_queues() can subsequently call into functions that
dereference these pointers without NULL checks:
- mana_chn_setxdp() dereferences apc->rxqs[0], causing a NULL pointer
dereference panic (CR2: 0000000000000000 at mana_chn_setxdp+0x26).
- mana_destroy_vport() iterates apc->rxqs without a NULL check.
- mana_fence_rqs() iterates apc->rxqs without a NULL check.
- mana_dealloc_queues() iterates apc->tx_qp without a NULL check.
Add NULL guards for apc->rxqs in mana_fence_rqs(),
mana_destroy_vport(), and before the mana_chn_setxdp() call. Add a
NULL guard for apc->tx_qp in mana_dealloc_queues() to skip TX queue
draining when TX queues were never allocated or already freed. |
| In the Linux kernel, the following vulnerability has been resolved:
ipv6: rpl: fix hdrlen overflow in ipv6_rpl_srh_decompress()
ipv6_rpl_srh_decompress() computes:
outhdr->hdrlen = (((n + 1) * sizeof(struct in6_addr)) >> 3);
hdrlen is __u8. For n >= 127 the result exceeds 255 and silently
truncates. With n=127 (cmpri=15, cmpre=15, pad=0, hdrlen=16):
(128 * 16) >> 3 = 256, truncated to 0 as __u8
The caller in ipv6_rpl_srh_rcv() then places the compressed header
at buf + ((ohdr->hdrlen + 1) << 3). With hdrlen=0 this is buf + 8,
but the decompressed region occupies buf[0..2055] (8-byte header
plus 128 full addresses). The compressed header overlaps the
decompressed data, and ipv6_rpl_srh_compress() writes into this
overlap, corrupting the routing header of the forwarded packet.
The existing guard at exthdrs.c:546 checks (n + 1) > 255, which
prevents n+1 from overflowing unsigned char (the segments_left
field), but does not prevent the computed hdrlen from overflowing
__u8. n=127 passes because 128 <= 255, yet hdrlen=256 does not
fit.
Tighten the bound to (n + 1) > 127. This caps n at 126, giving
hdrlen = (127 * 16) >> 3 = 254, which fits in __u8. The compressed
header then lands at buf + ((254 + 1) << 3) = buf + 2040, exactly
past the decompressed region (buf[0..2039]). No overlap. 127
segments is well beyond any realistic RPL deployment. |
| A flaw was found in pki-core. The certificate authority (CA) renewal request path does not perform the realm-based authorization check that the enrollment path performs, allowing an authenticated user entitled to one realm to cause a certificate belonging to a different realm to be renewed without that realm's authorization. |
| In the Linux kernel, the following vulnerability has been resolved:
security/keys: fix missed RCU read section on lookup
Nicholas Carlini reports that the keyring code calls assoc_array_find()
in find_key_to_update() without holding the RCU read lock, while the
assoc_array_gc() code really is designed around removing the node from
the tree and then freeing it after an RCU grace-period.
The regular key handling doesn't see this because holding the keyring
semaphore hides any lifetime issues, but the persistent key handling
uses a different model.
Instead of extending the keyring locking, just do the simple RCU locking
that the assoc_array was designed for. |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/rtrs: Fix use-after-free in path file creation cleanup
In the error path of rtrs_srv_create_path_files(), the sysfs root folders
may already have been created and srv_path->kobj may already have been
initialized. If a later step fails, the cleanup currently calls
kobject_put(&srv_path->kobj) before
rtrs_srv_destroy_once_sysfs_root_folders(srv_path).
kobject_put() may drop the last reference to srv_path->kobj and invoke the
release callback, rtrs_srv_release(), which frees srv_path. The following
call to rtrs_srv_destroy_once_sysfs_root_folders(srv_path) then
dereferences srv_path internally to access srv_path->srv, resulting in a
use-after-free.
This failure path is reached before rtrs_srv_create_path_files() returns
success, so the successful-path lifetime handling is not involved.
Fix this by destroying the sysfs root folders before calling
kobject_put(&srv_path->kobj), so srv_path is still valid while the helper
accesses it.
This issue was found by a static analysis tool I am developing. |
| In the Linux kernel, the following vulnerability has been resolved:
net: mana: Fix TOCTOU double-fetch of hwc_msg_id from DMA buffer
In mana_hwc_rx_event_handler(), resp->response.hwc_msg_id is read from
DMA-coherent memory and bounds-checked, then mana_hwc_handle_resp()
re-reads the same field from the same DMA buffer for test_bit() and
pointer arithmetic.
DMA-coherent memory is mapped uncacheable on x86 and is shared,
unencrypted, in Confidential VMs (SEV-SNP/TDX), so each load goes
directly to host-visible memory. A H/W can modify the value
between the check and the use, bypassing the bounds validation.
Fix this by reading hwc_msg_id exactly once using READ_ONCE() into a
stack-local variable in mana_hwc_rx_event_handler(), and passing the
validated value as a parameter to mana_hwc_handle_resp(). |
| In the Linux kernel, the following vulnerability has been resolved:
net: ethtool: phy: avoid NULL deref when PHY driver is unbound
phydev->drv can become NULL while the phy_device is still attached to
its net_device, namely after the PHY driver is unbound via sysfs:
echo <mdio_id> > /sys/bus/mdio_bus/drivers/<phy_drv>/unbind
phy_remove() clears phydev->drv but doesn't call phy_detach(), so the
phy_device stays in the link topology xarray and ethnl_req_get_phydev()
still hands it back. ETHTOOL_MSG_PHY_GET then oopses on:
rep_data->drvname = kstrdup(phydev->drv->name, GFP_KERNEL);
drvname is already treated as optional by phy_reply_size(),
phy_fill_reply() and phy_cleanup_data(), so just skip the allocation
when there is no driver bound. |
| The Tenda TX9 V22.03.02.05 firmware has a stack overflow vulnerability in the sub_4418CC function of the file /goform/SetNetControlList. |
| The Tenda TX9 V22.03.02.20 firmware has a denial of service vulnerability in the update_dev_name function of the file /goform/SetOnlineDevName |
| An issue in safishamsi Open-Source GRAPHIFY v.0.3.2 through v0.4.29 allows a remote attacker to execute arbitrary code via the validate_url, safe_fetch, _build_opener, _fetch_html and _download_binary functions. |
| Apache Neethi is vulnerable to uncontrolled recursion when parsing policies that lack policy Ids or with deeply nested structures, which may lead to a denial of service attack when parsing policies due to runtime memory exhaustion. Users are recommended to upgrade to version 3.2.3, which fixes this issue. |
| DOMPurify before 3.4.12 fails to execute afterSanitizeElements hook for custom elements allowed via CUSTOM_ELEMENT_HANDLING.tagNameCheck, allowing attributes to bypass application security policies. Attackers can preserve sensitive attributes on custom elements that later re-inject them into innerHTML sinks, creating second-order XSS gadgets. |
| A CSRF vulnerability exists in the `zone-include.php` script in Revive Adserver 6.0.7. Linking and unlinking banners or campaigns to zones could be triggered via crafted GET or POST requests without any verification of the CSRF token, allowing an attacker to perform these actions on behalf of an authenticated administrator. |
| The Zephyr ext2 file system validates the on-disk superblock in ext2_verify_disk_superblock() (subsys/fs/ext2/ext2_impl.c) before completing a mount. The validator checked the magic number, block size, revision and feature flags, but did not verify that the on-disk fields s_blocks_per_group and s_inodes_per_group are non-zero. Both fields are read directly from the image and are later used as divisors during mount-time initialization.
During mount, get_ngroups() divides and modulos s_blocks_count by s_blocks_per_group (reached via ext2_fetch_block_group() from ext2_init_fs()), and get_itable_entry() divides (ino - 1) by s_inodes_per_group when fetching the root inode (both in subsys/fs/ext2/ext2_diskops.c). A superblock with either field set to zero therefore causes an integer division by zero during the mount sequence.
An attacker who can present a crafted ext2 image to a device that mounts ext2 — removable media such as an SD card or a USB mass-storage device — can trigger this. On ARMv7-M / ARMv8-M-mainline Cortex-M targets, divide-by-zero trapping is enabled (SCB_CCR_DIV_0_TRP), so the division raises a UsageFault that Zephyr treats as a fatal error, producing a denial of service. The impact is limited to availability; the malformed value is consumed only as a divisor.
The fix rejects a zero s_blocks_per_group or s_inodes_per_group in the superblock validator, returning -EINVAL so the mount fails before any block-group or inode I/O occurs. |
| The Easy Appointments plugin for WordPress is vulnerable to unauthorized modification of data due to a missing capability check and missing nonce verification on the `ea_delete_multiple_connections` AJAX action in all versions up to, and including, 3.12.27. This makes it possible for authenticated attackers, with Contributor-level access and above, to delete arbitrary connection records from the `wp_ea_connections` table, disrupting the plugin's core booking functionality. |
| The WP Encryption – One Click Free SSL Certificate & SSL / HTTPS Redirect, Security & SSL Scan plugin for WordPress is vulnerable to Directory Traversal in all versions up to, and including, 7.8.6.6 via the 'imploded' parameter parameter. This makes it possible for authenticated attackers, with administrator-level access and above, to read the contents of arbitrary files on the server, which can contain sensitive information. Although file write content is passed through esc_html(), which encodes angle brackets and prevents direct PHP execution, plaintext configuration files such as .htaccess are fully writable and exploitable for denial-of-service or redirect attacks. This is only exploitable when the premium version of the software is enabled and active. |
| In the Linux kernel, the following vulnerability has been resolved:
gpio: shared: fix deadlock on shared proxy's parent removal
Commit 710abda58055 ("gpio: shared: call gpio_chip::of_xlate() if set")
used the mutex embedded in struct gpio_shared_entry to protect the
offset field which now can be modified after assignment. The critical
section however is too wide and introduced a potential deadlock on the
removal of the shared GPIO proxy's parent.
Make the critical section shorter - only protect the offset when it's
being read.
While at it: mention the fact that the entry lock is now also used to
protect against concurrent access to the offset field in the structure's
documentation. |
