| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Power Systems Firmware FW1120.00, FW1110.00 through FW1110.30, and FW1060.00 through FW1060.80 is affected by a vulnerability in the host firmware. An attacker with service access to the service processor can supply a carefully crafted command that could leak the contents of hardware registers that should be inaccessible to the service processor. Successful exploitation could result in limited confidentiality or availability impacts to the affected host system. |
| IBM PowerVM Hypervisor FW1120.00, FW1110.00 through FW1110.30, FW1060.00 through FW1060.80, and FW950.00 through FW950.H2 is affected by a vulnerability in the service processor mailbox interface. An attacker with authenticated service-level access to the FSP can exploit this vulnerability, allowing arbitrary code to be executed in the host firmware runtime, giving full control over the managed system, resulting in a confidentiality, integrity, and availability impact to the managed system. |
| OpenEXR is the reference implementation and specification for the EXR image format, widely used in the motion picture industry. In versions before 3.2.11, 3.3.0 through 3.3.12, and 3.4.0 through 3.4.13, a crafted tiled EXR can trigger a heap out-of-bounds write on 32-bit/ILP32 builds when read through the public TiledRgbaInputFile RGBA API. The file uses a small 40x40 dataWindow but a 65537x65537 tile size. On ILP32, the Array2D<Rgba> tile-conversion buffer size calculation overflows, allocates a much smaller heap buffer, and tile decode writes past that allocation. This issue is fixed in versions 3.2.11, 3.3.13, and 3.4.14. |
| OpenEXR is the reference implementation and specification for the EXR image format, widely used in the motion picture industry. In versions 3.1.0 through 3.2.10, 3.3.0 through 3.3.12, and 3.4.0 through 3.4.13, an int32_t multiplication in OpenEXRCore's unpack_sample_table() can overflow while decoding a crafted deep tiled EXR file, producing an invalid pointer that leads to a read from an unmapped memory address and a crash. Because the overflow occurs in the standard decoding path (exr_decoding_run), any application that decodes deep tiled EXR files is affected. This issue is fixed in versions 3.2.11, 3.3.13, and 3.4.14. |
| IBM Virtualization Management Interface FW1110.00 through FW1110.30, FW1120.00 through FW1120.00, and FW1060.00 through FW1060.80 is affected by a vulnerability in the Virtualization Management Interface (VMI). An attacker with authenticated administrator-level access can cause the VMI to crash. The VMI will restart automatically; however, repeated exploitation could result in a sustained availability impact. |
| hank-ai/darknet sizes a convolutional layer's weight and output heap buffers by multiplying configuration fields taken from a .cfg file in unchecked 32-bit int arithmetic. In src-lib/convolutional_layer.cpp, l.nweights is computed as (c / groups) * n * size * size and l.outputs as l.out_h * l.out_w * l.out_c, and both feed xcalloc directly. A .cfg whose true dimension product exceeds INT_MAX wraps to a small or zero value, so the allocation is undersized; for example width and height of 256 with filters of 65536 gives 2^32, which wraps to 0. forward_convolutional_layer then re-derives the GEMM dimensions with a different operand order, computing k as l.size*l.size*l.c / l.groups where the allocation divided before multiplying, and reads and writes through the undersized buffer. Loading the crafted .cfg for inference or training is sufficient and no valid .weights file is required. The reported proof of concept observed a heap buffer overflow read in gemm_nn_fast under AddressSanitizer and glibc allocator metadata corruption in a release build of the same input, indicating an out-of-bounds write. |
| libvips is a fast image processing library with low memory needs. Prior to version 8.18.3, libvips built without libtiff support but with ImageMagick support can overflow the combined frame height while loading a crafted multi-page TIFF through VipsForeignLoadMagick. The vulnerable calculations in libvips/foreign/magick6load.c and libvips/foreign/magick7load.c multiply the per-page Ysize by n_frames without a checked bound, which can cause a heap buffer over-read and process crash. Most package-manager builds include libtiff and do not use this affected fallback path. This issue is fixed in version 8.18.3. |
| Libevent is an event notification library. Prior to 2.1.13 and 2.2.2-alpha, libevent has an off-by-one stack buffer overflow in evdns.c when dnsname_to_labels formats a name-bearing DNS record at the end of the 64 KB stack buffer allocated by evdns_server_request_format_response. The final-label check permits j plus label_len plus one to equal buf_len, after which the terminating null byte is written to buf[buf_len]. A crafted DNS server response containing PTR, CNAME, MX, NS, or SOA data can trigger the one-byte out-of-bounds write and crash or corrupt the process. This issue is fixed in versions 2.1.13 and 2.2.2-alpha. |
| OpenEXR is the reference implementation and specification for the EXR image format, widely used in the motion picture industry. In versions 3.4.0 through 3.4.12, a reachable assertion failure in the HTJ2K decode path allows a crafted HTJ2K-compressed EXR file to cause an unconditional process abort in any application that calls exr_start_read() on untrusted input, resulting in denial of service. The crash is triggered by a QCD marker whose lower five bits are zero, which OpenEXR passes into the vendored OpenJPH library while constructing the codestream and evaluating its quantization delta parameters. OpenJPH uses an assertion rather than a recoverable error to validate those bits, so any invalid value calls abort() directly and cannot be intercepted by surrounding error handling, a problem compounded by OpenEXR wrapping only its internal HT header parser in error handling while leaving the later codestream read and construction calls unprotected. This issue has been resolved in version 3.4.13. |
| Integer overflow in the Graphics component. This vulnerability was fixed in Firefox 154, Firefox ESR 153.1, Thunderbird 154, and Thunderbird 153.1. |
| In the Linux kernel, the following vulnerability has been resolved:
hwmon: (ltc4282) Clamp negative current limits
When a negative value is passed to ltc4282_write_curr(), the signed long
val is cast directly to u64:
drivers/hwmon/ltc4282.c:ltc4282_write_curr() {
/* need to pass it in millivolt */
u32 in = DIV_ROUND_CLOSEST_ULL((u64)val * st->rsense, DECA * MICRO);
...
}
This cast converts negative inputs into large positive values. The
subsequent division result overflows the u32 in variable, truncating
to a pseudo-random positive value. When this is passed to
ltc4282_write_voltage_byte(), it is clamped to the maximum limit instead
of zero.
Clamp val to 0 and to the maximum supported upper limit before the cast
and assign the result to a 64-bit temporary variable before the division
to avoid the underflow and an also possible overflow. |
| In the Linux kernel, the following vulnerability has been resolved:
vhost-scsi: Validate T10 PI scatterlist counts
When T10 PI is negotiated, vhost-scsi splits protection bytes from
the data iterator before mapping the request scatterlists. A malformed
request can claim protection bytes that cover or exceed the full payload
length. The former leaves no data bytes to map, while the latter
underflows exp_data_len before advancing the iterator. Both cases can let
a zero data SGL count reach sg_alloc_table_chained(), which triggers
BUG_ON(!nents).
Reject protection lengths that cover or exceed the payload before
subtracting prot_bytes and advancing the iterator. Also propagate
negative errors from the protection SGL calculation before calling the
allocator, matching the data SGL path. |
| A flaw was found in libsoup's SoupServer HTTP Range header processing. The sort_ranges() comparator in soup-message-headers.c truncates a 64-bit subtraction result to 32-bit int, flipping the sign for range offsets differing by more than INT_MAX. This causes silent omission of requested byte ranges from HTTP 206 Partial Content responses on resources larger than approximately 2 GB. |
| In the Linux kernel, the following vulnerability has been resolved:
tcp: fix TFO max_qlen accounting across reuseport migration
A listener's TCP_FASTOPEN max_qlen stops being accurate and lets through
far more pending Fast Open requests than it was configured for.
This only shows up with SO_REUSEPORT listener migration, where closing a
listener hands its still-pending TFO children over to a surviving one.
fastopenq.qlen is charged in tcp_fastopen_create_child() when the child
is created and uncharged in reqsk_fastopen_remove() when the handshake
completes. The uncharge follows rsk_listener of the request the child
points at, and inet_reqsk_clone() has repointed the child at a new
request owned by the new listener, so the ++ and the -- land on two
different sockets. The new listener's qlen drifts negative and its
limit no longer binds.
Charge the new listener during migration, like reqsk_queue_migrated()
already does for queue->young and queue->qlen. |
| A flaw was found in open-iscsi. An integer underflow vulnerability in the `iscsiuio` component, specifically during IPv4 Dynamic Host Configuration Protocol (DHCP) parsing, allows a remote attacker on the same local network segment to cause a denial of service. By sending a specially crafted IPv4/UDP DHCP reply, the attacker can trigger an out-of-bounds read, leading to the `iscsiuio` process crashing. This issue affects systems where `iscsiuio` is actively handling IPv4 DHCP traffic. |
| A flaw was found in open-iscsi's iscsiuio component. This vulnerability involves an integer underflow and out-of-bounds read during Dynamic Host Configuration Protocol for IPv6 (DHCPv6) packet parsing. Specifically, crafted DHCPv6 Advertise traffic with a short User Datagram Protocol (UDP) length can cause the DHCPv6 payload length to underflow. An unauthenticated attacker on an adjacent network segment can exploit this by sending specially crafted IPv6 UDP traffic while the client is in an active DHCPv6 exchange, leading to a denial of service due to a process crash or service disruption. |
| OpenEXR is the reference implementation and specification for the EXR image format, widely used in the motion picture industry. Versions prior to 3.2.10, 3.3.12, and 3.4.13 contain an infinite-loop vulnerability in SampleCountChannel. The helper roundListSizeUp() rounds a sample-list size up to the next power of two using repeated unsigned left shifts, which terminates for normal values but fails for UINT_MAX: the sequence reaches 0x80000000, and the next left shift wraps the 32-bit value to 0. Because 0 remains less than UINT_MAX, the loop never progresses and never exits. The bug is reachable through public OpenEXRUtil APIs, either by editing the sample-count buffer through SampleCountChannel::Edit (whose destructor calls endEdit()) or by calling SampleCountChannel::set(x, y, UINT_MAX) on a valid pixel. This issue has been fixed in versions 3.2.10, 3.3.12, and 3.4.13. |
| IBM Power Systems Firmware FW1120.00, FW1110.00 through FW1110.30, FW1060.00 through FW1060.80, FW950.00 through FW950.H2, OP940.00 through OP940.a1 (Power9), and OP940.00 through OP940.81 (Power HMC) is affected by a vulnerability in the interface between the BMC/FSP and the host system. An attacker with service account or root access to the BMC/FSP can read and write arbitrary regions of host system memory, giving full control over the host system and all hosted partitions, resulting in a confidentiality, integrity, and availability impact. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a local attacker to execute arbitrary code due to an integer underflow. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote attacker to cause a denial of service and potentially disclose sensitive information due to an integer underflow. |
