| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability was detected in Edimax EW-7478APC 1.04. Affected is the function formWlSiteSurvey of the file /goform/formWlSiteSurvey. Performing a manipulation of the argument selSSID results in buffer overflow. The attack is possible to be carried out remotely. The exploit is now public and may be used. The vendor was contacted early about this disclosure but did not respond in any way. |
| A vulnerability was determined in Wavlink WN531P3 and WN535M1 V250922. Affected by this vulnerability is the function strcpy of the file /etc/lighttpd/www/cgi-bin/export_pingortrace.cgi of the component Export Pingortrace CGI. Executing a manipulation of the argument HTTP_COOKIE can lead to stack-based buffer overflow. The attack may be launched remotely. The exploit has been publicly disclosed and may be utilized. The vendor was contacted early about this disclosure. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: meson: aiu: Validate written enum values
The AIU HDMI and internal codec mux put callbacks use the written enum
value with snd_soc_enum_item_to_val() before checking whether the value is
valid for the enumeration.
Reject out-of-range values before converting the enum item, matching the
validation already done by the G12A HDMI and internal codec mux controls. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: ath9k: fix OOB access from firmware tx status queue ID
ath_tx_edma_tasklet() accesses sc->tx.txq[ts.qid] where ts.qid is a
4-bit hardware field (0-15), but the txq array only has
ATH9K_NUM_TX_QUEUES (10) entries. A qid >= 10 causes an OOB array
access.
Add a bounds check on ts.qid before using it as an array index. |
| In the Linux kernel, the following vulnerability has been resolved:
iommu/arm-smmu-v3-iommufd: Require exactly one Stream ID for a vDEVICE
arm_vsmmu_vsid_to_sid() maps a guest's vSID to a single physical Stream ID
taken from master->streams[0], assuming a device has exactly one stream. A
device with several streams gets only its first one mapped, so a guest vSID
invalidation cannot reach the others' ATC and IOTLB entries; a device with
none makes master->streams a ZERO_SIZE_PTR, read out of bounds.
Add an arm_vsmmu_vdevice_init() op to reject the vDEVICE with -EOPNOTSUPP
when master->num_streams is not one, rather than mapping it silently. |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: ccp - Fix snp_filter_reserved_mem_regions() off-by-one
Sashiko notes:
> regarding the bounds check in snp_filter_reserved_mem_regions()
> called via walk_iomem_res_desc(): does the check
> if ((range_list->num_elements * 16 + 8) > PAGE_SIZE)
> allow an off-by-one heap buffer overflow?
>
> If range_list->num_elements is 255, 255 * 16 + 8 = 4088, which is <= 4096.
> Writing range->base (8 bytes) fills 4088-4095, but writing range->page_count
> (4 bytes) would write to 4096-4099, overflowing the kzalloc-allocated
> PAGE_SIZE buffer.
Fix this by accounting for the entry about to be written to, in addition to
the entries that are already allocated. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: SOF: ipc3-control: Validate size in snd_sof_update_control
In snd_sof_update_control(), firmware-provided cdata->num_elems is
checked against local_cdata->data->size but never against the actual
allocation size. If local_cdata->data->size was previously set to an
inconsistent value, the memcpy could write past the allocated buffer.
Add a bounds check to ensure num_elems fits within the available space
in the ipc_control_data allocation before copying. |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Reject negative const offsets for buffer pointers
The verifier rejects variable offsets for PTR_TO_TP_BUFFER and PTR_TO_BUF
accesses, but it currently accepts a constant negative offset produced by
pointer arithmetic.
Commit 022ac0750883 ("bpf: use reg->var_off instead of reg->off for
pointers") moved constant pointer offsets from reg->off to reg->var_off.
However, __check_buffer_access() continued to check only the instruction
offset. An access with reg->var_off equal to -8 and an instruction offset
of zero therefore passes verification.
For writable raw tracepoints, the access end is also calculated from the
unsigned reg->var_off.value. An eight-byte access starting at -8 wraps
the calculated end to zero, allowing the program to load and attach
without increasing max_tp_access.
After ensuring that reg->var_off is constant, calculate the effective
access start using signed arithmetic and reject it when it is negative.
Use the validated start to calculate the access end for both
PTR_TO_TP_BUFFER and PTR_TO_BUF. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7925: validate skb length in testmode query
In mt7925_tm_query(), the response skb from mt76_mcu_send_and_get_msg()
is used in a memcpy without validating its length:
memcpy(evt_resp, skb->data + 8, MT7925_EVT_RSP_LEN);
where MT7925_EVT_RSP_LEN is 512. If the firmware returns a response
shorter than 520 bytes (8 + 512), this reads beyond the skb data
buffer. The over-read data is then returned to userspace via nla_put()
in mt7925_testmode_dump().
Add a length check before the memcpy to ensure the skb contains
sufficient data. |
| In the Linux kernel, the following vulnerability has been resolved:
Input: ims-pcu - fix type confusion in CDC union descriptor parsing
The driver currently trusts the bMasterInterface0 from the CDC union
descriptor without verifying that it matches the interface being
probed. This could lead to the driver overwriting the private data of
another interface.
Validate that the control interface found in the descriptor is indeed
the one we are probing. |
| A weakness has been identified in Edimax EW-7478APC 1.04. This affects the function formWanTcpipSetup of the file /goform/formWanTcpipSetup. This manipulation of the argument pppUserName causes stack-based buffer overflow. Remote exploitation of the attack is possible. The exploit has been made available to the public and could be used for attacks. The vendor was contacted early about this disclosure but did not respond in any way. |
| A weakness has been identified in DefaultFuction Customer-Relationship-Management-In-C-Project 2.0. Impacted is the function gets of the component Customer Search Module. This manipulation causes stack-based buffer overflow. The attack may be initiated remotely. The exploit has been made available to the public and could be used for attacks. The project confirms, that "it’s being processed". |
| As part of Cisco's ongoing commitment to proactive security and product quality, the Cisco IOS XE Software engineering team has conducted a comprehensive internal security review. This review resulted in software hardening releases that address multiple internally discovered vulnerabilities.
The vulnerabilities tracked by CVE-2026-20268 are related to issues with improper restriction of operations within the bounds of a memory buffer that are grouped under the Common Weakness Enumeration (CWE) Pillar CWE-119. |
| As part of Cisco's ongoing commitment to proactive security and product quality, the Cisco RoomOS engineering team has conducted a comprehensive internal security review. This review resulted in a software hardening release that addresses multiple internally discovered vulnerabilities.
The vulnerabilities tracked by CVE-2026-20156 are related to improper restriction of operations within the bounds of a memory buffer that are grouped under the Common Weakness Enumeration (CWE) Pillar CWE-119. |
| A vulnerability was determined in TOTOLINK A800R 4.1.2cu.5137_B20200730. This affects the function setStaticDhcpConfig of the file /cgi-bin/cstecgi.cgi of the component lan.so. Executing a manipulation of the argument Comment can lead to stack-based buffer overflow. It is possible to launch the attack remotely. The exploit has been publicly disclosed and may be utilized. |
| A vulnerability was identified in TOTOLINK A800R 4.1.2cu.5137_B20200730. This impacts the function setUrlFilterRules of the file /cgi-bin/cstecgi.cgi of the component firewall.so. The manipulation of the argument url leads to stack-based buffer overflow. The attack can be initiated remotely. The exploit is publicly available and might be used. |
| A vulnerability was detected in TOTOLINK A800R 4.1.2cu.5137_B20200730. Affected is the function setMacQos of the file /cgi-bin/cstecgi.cgi of the component firewall.so. Performing a manipulation of the argument macAddress results in stack-based buffer overflow. It is possible to initiate the attack remotely. The exploit is now public and may be used. |
| A vulnerability was identified in Tenda W20E 15.11.0.6(1068_1546_841)_CN_TDC. This issue affects the function lstAdd of the file /goform/editQos of the component QoS Edit. Such manipulation of the argument qosListConnecttedNum leads to stack-based buffer overflow. The attack may be launched remotely. The exploit is publicly available and might be used. |
| A weakness has been identified in TOTOLINK A800R 4.1.2cu.5137_B20200730. This affects the function UploadCustomModule of the file /cgi-bin/cstecgi.cgi of the component product.so. This manipulation of the argument File causes stack-based buffer overflow. The attack is possible to be carried out remotely. The exploit has been made available to the public and could be used for attacks. |
| A weakness has been identified in Tenda G0 up to 20260625. The affected element is the function addStaticRoute of the file /goform/module of the component httpd web management interface. Executing a manipulation of the argument staticRouteNet can lead to stack-based buffer overflow. The attack may be performed from remote. The exploit has been made available to the public and could be used for attacks. |
