| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: nft_set_pipapo_avx2: don't return non-matching entry on expiry
New test case fails unexpectedly when avx2 matching functions are used.
The test first loads a ranomly generated pipapo set
with 'ipv4 . port' key, i.e. nft -f foo.
This works. Then, it reloads the set after a flush:
(echo flush set t s; cat foo) | nft -f -
This is expected to work, because its the same set after all and it was
already loaded once.
But with avx2, this fails: nft reports a clashing element.
The reported clash is of following form:
We successfully re-inserted
a . b
c . d
Then we try to insert a . d
avx2 finds the already existing a . d, which (due to 'flush set') is marked
as invalid in the new generation. It skips the element and moves to next.
Due to incorrect masking, the skip-step finds the next matching
element *only considering the first field*,
i.e. we return the already reinserted "a . b", even though the
last field is different and the entry should not have been matched.
No such error is reported for the generic c implementation (no avx2) or when
the last field has to use the 'nft_pipapo_avx2_lookup_slow' fallback.
Bisection points to
7711f4bb4b36 ("netfilter: nft_set_pipapo: fix range overlap detection")
but that fix merely uncovers this bug.
Before this commit, the wrong element is returned, but erronously
reported as a full, identical duplicate.
The root-cause is too early return in the avx2 match functions.
When we process the last field, we should continue to process data
until the entire input size has been consumed to make sure no stale
bits remain in the map. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: brcmfmac: validate bsscfg indices in IF events
brcmf_fweh_handle_if_event() validates the firmware-provided interface
index before it touches drvr->iflist[], but it still uses the raw
bsscfgidx field as an array index without a matching range check.
Reject IF events whose bsscfg index does not fit in drvr->iflist[]
before indexing the interface array.
[add missing wifi prefix] |
| In the Linux kernel, the following vulnerability has been resolved:
net: lapbether: handle NETDEV_PRE_TYPE_CHANGE
lapbeth_data_transmit() expects the underlying device type
to be ARPHRD_ETHER.
Returning NOTIFY_BAD from lapbeth_device_event() makes sure
bonding driver can not break this expectation. |
| In the Linux kernel, the following vulnerability has been resolved:
xsk: tighten UMEM headroom validation to account for tailroom and min frame
The current headroom validation in xdp_umem_reg() could leave us with
insufficient space dedicated to even receive minimum-sized ethernet
frame. Furthermore if multi-buffer would come to play then
skb_shared_info stored at the end of XSK frame would be corrupted.
HW typically works with 128-aligned sizes so let us provide this value
as bare minimum.
Multi-buffer setting is known later in the configuration process so
besides accounting for 128 bytes, let us also take care of tailroom space
upfront. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/vc4: platform_get_irq_byname() returns an int
platform_get_irq_byname() will return a negative value if an error
happens, so it should be checked and not just passed directly into
devm_request_threaded_irq() hoping all will be ok. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: check tdls flag in ieee80211_tdls_oper
When NL80211_TDLS_ENABLE_LINK is called, the code only checks if the
station exists but not whether it is actually a TDLS station. This
allows the operation to proceed for non-TDLS stations, causing
unintended side effects like modifying channel context and HT
protection before failing.
Add a check for sta->sta.tdls early in the ENABLE_LINK case, before
any side effects occur, to ensure the operation is only allowed for
actual TDLS peers. |
| In the Linux kernel, the following vulnerability has been resolved:
ksmbd: validate owner of durable handle on reconnect
Currently, ksmbd does not verify if the user attempting to reconnect
to a durable handle is the same user who originally opened the file.
This allows any authenticated user to hijack an orphaned durable handle
by predicting or brute-forcing the persistent ID.
According to MS-SMB2, the server MUST verify that the SecurityContext
of the reconnect request matches the SecurityContext associated with
the existing open.
Add a durable_owner structure to ksmbd_file to store the original opener's
UID, GID, and account name. and catpure the owner information when a file
handle becomes orphaned. and implementing ksmbd_vfs_compare_durable_owner()
to validate the identity of the requester during SMB2_CREATE (DHnC). |
| In the Linux kernel, the following vulnerability has been resolved:
ksmbd: use check_add_overflow() to prevent u16 DACL size overflow
set_posix_acl_entries_dacl() and set_ntacl_dacl() accumulate ACE sizes
in u16 variables. When a file has many POSIX ACL entries, the
accumulated size can wrap past 65535, causing the pointer arithmetic
(char *)pndace + *size to land within already-written ACEs. Subsequent
writes then overwrite earlier entries, and pndacl->size gets a
truncated value.
Use check_add_overflow() at each accumulation point to detect the
wrap before it corrupts the buffer, consistent with existing
check_mul_overflow() usage elsewhere in smbacl.c. |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: caiaq: take a reference on the USB device in create_card()
The caiaq driver stores a pointer to the parent USB device in
cdev->chip.dev but never takes a reference on it. The card's
private_free callback, snd_usb_caiaq_card_free(), can run
asynchronously via snd_card_free_when_closed() after the USB
device has already been disconnected and freed, so any access to
cdev->chip.dev in that path dereferences a freed usb_device.
On top of the refcounting issue, the current card_free implementation
calls usb_reset_device(cdev->chip.dev). A reset in a free callback
is inappropriate: the device is going away, the call takes the
device lock in a teardown context, and the reset races with the
disconnect path that the callback is already cleaning up after.
Take a reference on the USB device in create_card() with
usb_get_dev(), drop it with usb_put_dev() in the free callback,
and remove the usb_reset_device() call. |
| In the Linux kernel, the following vulnerability has been resolved:
fuse: reject oversized dirents in page cache
fuse_add_dirent_to_cache() computes a serialized dirent size from the
server-controlled namelen field and copies the dirent into a single
page-cache page. The existing logic only checks whether the dirent fits
in the remaining space of the current page and advances to a fresh page
if not. It never checks whether the dirent itself exceeds PAGE_SIZE.
As a result, a malicious FUSE server can return a dirent with
namelen=4095, producing a serialized record size of 4120 bytes. On 4 KiB
page systems this causes memcpy() to overflow the cache page by 24 bytes
into the following kernel page.
Reject dirents that cannot fit in a single page before copying them into
the readdir cache. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: ip6t_eui64: reject invalid MAC header for all packets
`eui64_mt6()` derives a modified EUI-64 from the Ethernet source address
and compares it with the low 64 bits of the IPv6 source address.
The existing guard only rejects an invalid MAC header when
`par->fragoff != 0`. For packets with `par->fragoff == 0`, `eui64_mt6()`
can still reach `eth_hdr(skb)` even when the MAC header is not valid.
Fix this by removing the `par->fragoff != 0` condition so that packets
with an invalid MAC header are rejected before accessing `eth_hdr(skb)`. |
| In the Linux kernel, the following vulnerability has been resolved:
net: sched: act_csum: validate nested VLAN headers
tcf_csum_act() walks nested VLAN headers directly from skb->data when an
skb still carries in-payload VLAN tags. The current code reads
vlan->h_vlan_encapsulated_proto and then pulls VLAN_HLEN bytes without
first ensuring that the full VLAN header is present in the linear area.
If only part of an inner VLAN header is linearized, accessing
h_vlan_encapsulated_proto reads past the linear area, and the following
skb_pull(VLAN_HLEN) may violate skb invariants.
Fix this by requiring pskb_may_pull(skb, VLAN_HLEN) before accessing and
pulling each nested VLAN header. If the header still is not fully
available, drop the packet through the existing error path. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: xt_multiport: validate range encoding in checkentry
ports_match_v1() treats any non-zero pflags entry as the start of a
port range and unconditionally consumes the next ports[] element as
the range end.
The checkentry path currently validates protocol, flags and count, but
it does not validate the range encoding itself. As a result, malformed
rules can mark the last slot as a range start or place two range starts
back to back, leaving ports_match_v1() to step past the last valid
ports[] element while interpreting the rule.
Reject malformed multiport v1 rules in checkentry by validating that
each range start has a following element and that the following element
is not itself marked as another range start. |
| In the Linux kernel, the following vulnerability has been resolved:
rxrpc: only handle RESPONSE during service challenge
Only process RESPONSE packets while the service connection is still in
RXRPC_CONN_SERVICE_CHALLENGING. Check that state under state_lock before
running response verification and security initialization, then use a local
secured flag to decide whether to queue the secured-connection work after
the state transition. This keeps duplicate or late RESPONSE packets from
re-running the setup path and removes the unlocked post-transition state
test. |
| In the Linux kernel, the following vulnerability has been resolved:
af_unix: read UNIX_DIAG_VFS data under unix_state_lock
Exact UNIX diag lookups hold a reference to the socket, but not to
u->path. Meanwhile, unix_release_sock() clears u->path under
unix_state_lock() and drops the path reference after unlocking.
Read the inode and device numbers for UNIX_DIAG_VFS while holding
unix_state_lock(), then emit the netlink attribute after dropping the
lock.
This keeps the VFS data stable while the reply is being built. |
| In the Linux kernel, the following vulnerability has been resolved:
xfrm: clear trailing padding in build_polexpire()
build_expire() clears the trailing padding bytes of struct
xfrm_user_expire after setting the hard field via memset_after(),
but the analogous function build_polexpire() does not do this for
struct xfrm_user_polexpire.
The padding bytes after the __u8 hard field are left
uninitialized from the heap allocation, and are then sent to
userspace via netlink multicast to XFRMNLGRP_EXPIRE listeners,
leaking kernel heap memory contents.
Add the missing memset_after() call, matching build_expire(). |
| In the Linux kernel, the following vulnerability has been resolved:
rxrpc: reject undecryptable rxkad response tickets
rxkad_decrypt_ticket() decrypts the RXKAD response ticket and then
parses the buffer as plaintext without checking whether
crypto_skcipher_decrypt() succeeded.
A malformed RESPONSE can therefore use a non-block-aligned ticket
length, make the decrypt operation fail, and still drive the ticket
parser with attacker-controlled bytes.
Check the decrypt result and abort the connection with RXKADBADTICKET
when ticket decryption fails. |
| In the Linux kernel, the following vulnerability has been resolved:
rxrpc: proc: size address buffers for %pISpc output
The AF_RXRPC procfs helpers format local and remote socket addresses into
fixed 50-byte stack buffers with "%pISpc".
That is too small for the longest current-tree IPv6-with-port form the
formatter can produce. In lib/vsprintf.c, the compressed IPv6 path uses a
dotted-quad tail not only for v4mapped addresses, but also for ISATAP
addresses via ipv6_addr_is_isatap().
As a result, a case such as
[ffff:ffff:ffff:ffff:0:5efe:255.255.255.255]:65535
is possible with the current formatter. That is 50 visible characters, so
51 bytes including the trailing NUL, which does not fit in the existing
char[50] buffers used by net/rxrpc/proc.c.
Size the buffers from the formatter's maximum textual form and switch the
call sites to scnprintf().
Changes since v1:
- correct the changelog to cite the actual maximum current-tree case
explicitly
- frame the proof around the ISATAP formatting path instead of the earlier
mapped-v4 example |
| In the Linux kernel, the following vulnerability has been resolved:
i2c: s3c24xx: check the size of the SMBUS message before using it
The first byte of an i2c SMBUS message is the size, and it should be
verified to ensure that it is in the range of 0..I2C_SMBUS_BLOCK_MAX
before processing it.
This is the same logic that was added in commit a6e04f05ce0b ("i2c:
tegra: check msg length in SMBUS block read") to the i2c tegra driver. |
| In the Linux kernel, the following vulnerability has been resolved:
HID: core: clamp report_size in s32ton() to avoid undefined shift
s32ton() shifts by n-1 where n is the field's report_size, a value that
comes directly from a HID device. The HID parser bounds report_size
only to <= 256, so a broken HID device can supply a report descriptor
with a wide field that triggers shift exponents up to 256 on a 32-bit
type when an output report is built via hid_output_field() or
hid_set_field().
Commit ec61b41918587 ("HID: core: fix shift-out-of-bounds in
hid_report_raw_event") added the same n > 32 clamp to the function
snto32(), but s32ton() was never given the same fix as I guess syzbot
hadn't figured out how to fuzz a device the same way.
Fix this up by just clamping the max value of n, just like snto32()
does. |
