| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Skip scalar adjustment for BPF_NEG if dst is a pointer
In check_alu_op(), the verifier currently calls check_reg_arg() and
adjust_scalar_min_max_vals() unconditionally for BPF_NEG operations.
However, if the destination register holds a pointer, these scalar
adjustments are unnecessary and potentially incorrect.
This patch adds a check to skip the adjustment logic when the destination
register contains a pointer. |
| In the Linux kernel, the following vulnerability has been resolved:
net: dlink: handle copy_thresh allocation failure
The driver did not handle failure of `netdev_alloc_skb_ip_align()`.
If the allocation failed, dereferencing `skb->protocol` could lead to
a NULL pointer dereference.
This patch tries to allocate `skb`. If the allocation fails, it falls
back to the normal path.
Tested-on: D-Link DGE-550T Rev-A3 |
| In the Linux kernel, the following vulnerability has been resolved:
coresight: Fix incorrect handling for return value of devm_kzalloc
The return value of devm_kzalloc could be an null pointer,
use "!desc.pdata" to fix incorrect handling return value
of devm_kzalloc. |
| In the Linux kernel, the following vulnerability has been resolved:
coresight: trbe: Return NULL pointer for allocation failures
When the TRBE driver fails to allocate a buffer, it currently returns
the error code "-ENOMEM". However, the caller etm_setup_aux() only
checks for a NULL pointer, so it misses the error. As a result, the
driver continues and eventually causes a kernel panic.
Fix this by returning a NULL pointer from arm_trbe_alloc_buffer() on
allocation failures. This allows that the callers can properly handle
the failure. |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/rxe: Fix race in do_task() when draining
When do_task() exhausts its iteration budget (!ret), it sets the state
to TASK_STATE_IDLE to reschedule, without a secondary check on the
current task->state. This can overwrite the TASK_STATE_DRAINING state
set by a concurrent call to rxe_cleanup_task() or rxe_disable_task().
While state changes are protected by a spinlock, both rxe_cleanup_task()
and rxe_disable_task() release the lock while waiting for the task to
finish draining in the while(!is_done(task)) loop. The race occurs if
do_task() hits its iteration limit and acquires the lock in this window.
The cleanup logic may then proceed while the task incorrectly
reschedules itself, leading to a potential use-after-free.
This bug was introduced during the migration from tasklets to workqueues,
where the special handling for the draining case was lost.
Fix this by restoring the original pre-migration behavior. If the state is
TASK_STATE_DRAINING when iterations are exhausted, set cont to 1 to
force a new loop iteration. This allows the task to finish its work, so
that a subsequent iteration can reach the switch statement and correctly
transition the state to TASK_STATE_DRAINED, stopping the task as intended. |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: hisilicon/qm - set NULL to qm->debug.qm_diff_regs
When the initialization of qm->debug.acc_diff_reg fails,
the probe process does not exit. However, after qm->debug.qm_diff_regs is
freed, it is not set to NULL. This can lead to a double free when the
remove process attempts to free it again. Therefore, qm->debug.qm_diff_regs
should be set to NULL after it is freed. |
| In the Linux kernel, the following vulnerability has been resolved:
RISC-V: KVM: Write hgatp register with valid mode bits
According to the RISC-V Privileged Architecture Spec, when MODE=Bare
is selected,software must write zero to the remaining fields of hgatp.
We have detected the valid mode supported by the HW before, So using a
valid mode to detect how many vmid bits are supported. |
| In the Linux kernel, the following vulnerability has been resolved:
fs: ntfs3: Fix integer overflow in run_unpack()
The MFT record relative to the file being opened contains its runlist,
an array containing information about the file's location on the physical
disk. Analysis of all Call Stack paths showed that the values of the
runlist array, from which LCNs are calculated, are not validated before
run_unpack function.
The run_unpack function decodes the compressed runlist data format
from MFT attributes (for example, $DATA), converting them into a runs_tree
structure, which describes the mapping of virtual clusters (VCN) to
logical clusters (LCN). The NTFS3 subsystem also has a shortcut for
deleting files from MFT records - in this case, the RUN_DEALLOCATE
command is sent to the run_unpack input, and the function logic
provides that all data transferred to the runlist about file or
directory is deleted without creating a runs_tree structure.
Substituting the runlist in the $DATA attribute of the MFT record for an
arbitrary file can lead either to access to arbitrary data on the disk
bypassing access checks to them (since the inode access check
occurs above) or to destruction of arbitrary data on the disk.
Add overflow check for addition operation.
Found by Linux Verification Center (linuxtesting.org) with SVACE. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/msm: Fix obj leak in VM_BIND error path
If we fail a handle-lookup part way thru, we need to drop the already
obtained obj references.
Patchwork: https://patchwork.freedesktop.org/patch/669784/ |
| In the Linux kernel, the following vulnerability has been resolved:
tty: n_gsm: Don't block input queue by waiting MSC
Currently gsm_queue() processes incoming frames and when opening
a DLC channel it calls gsm_dlci_open() which calls gsm_modem_update().
If basic mode is used it calls gsm_modem_upd_via_msc() and it
cannot block the input queue by waiting the response to come
into the same input queue.
Instead allow sending Modem Status Command without waiting for remote
end to respond. Define a new function gsm_modem_send_initial_msc()
for this purpose. As MSC is only valid for basic encoding, it does
not do anything for advanced or when convergence layer type 2 is used. |
| In the Linux kernel, the following vulnerability has been resolved:
tcp_metrics: use dst_dev_net_rcu()
Replace three dst_dev() with a lockdep enabled helper. |
| In the Linux kernel, the following vulnerability has been resolved:
PCI: rcar-host: Pass proper IRQ domain to generic_handle_domain_irq()
Starting with commit dd26c1a23fd5 ("PCI: rcar-host: Switch to
msi_create_parent_irq_domain()"), the MSI parent IRQ domain is NULL because
the object of type struct irq_domain_info passed to:
msi_create_parent_irq_domain() ->
irq_domain_instantiate()() ->
__irq_domain_instantiate()
has no reference to the parent IRQ domain. Using msi->domain->parent as an
argument for generic_handle_domain_irq() leads to below error:
"Unable to handle kernel NULL pointer dereference at virtual address"
This error was identified while switching the upcoming RZ/G3S PCIe host
controller driver to msi_create_parent_irq_domain() (which was using a
similar pattern to handle MSIs (see link section)), but it was not tested
on hardware using the pcie-rcar-host controller driver due to lack of
hardware.
[mani: reworded subject and description] |
| In the Linux kernel, the following vulnerability has been resolved:
f2fs: fix to avoid overflow while left shift operation
Should cast type of folio->index from pgoff_t to loff_t to avoid overflow
while left shift operation. |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Explicitly check accesses to bpf_sock_addr
Syzkaller found a kernel warning on the following sock_addr program:
0: r0 = 0
1: r2 = *(u32 *)(r1 +60)
2: exit
which triggers:
verifier bug: error during ctx access conversion (0)
This is happening because offset 60 in bpf_sock_addr corresponds to an
implicit padding of 4 bytes, right after msg_src_ip4. Access to this
padding isn't rejected in sock_addr_is_valid_access and it thus later
fails to convert the access.
This patch fixes it by explicitly checking the various fields of
bpf_sock_addr in sock_addr_is_valid_access.
I checked the other ctx structures and is_valid_access functions and
didn't find any other similar cases. Other cases of (properly handled)
padding are covered in new tests in a subsequent patch. |
| In the Linux kernel, the following vulnerability has been resolved:
nbd: restrict sockets to TCP and UDP
Recently, syzbot started to abuse NBD with all kinds of sockets.
Commit cf1b2326b734 ("nbd: verify socket is supported during setup")
made sure the socket supported a shutdown() method.
Explicitely accept TCP and UNIX stream sockets. |
| In the Linux kernel, the following vulnerability has been resolved:
net/sched: sch_qfq: Fix null-deref in agg_dequeue
To prevent a potential crash in agg_dequeue (net/sched/sch_qfq.c)
when cl->qdisc->ops->peek(cl->qdisc) returns NULL, we check the return
value before using it, similar to the existing approach in sch_hfsc.c.
To avoid code duplication, the following changes are made:
1. Changed qdisc_warn_nonwc(include/net/pkt_sched.h) into a static
inline function.
2. Moved qdisc_peek_len from net/sched/sch_hfsc.c to
include/net/pkt_sched.h so that sch_qfq can reuse it.
3. Applied qdisc_peek_len in agg_dequeue to avoid crashing. |
| In the Linux kernel, the following vulnerability has been resolved:
ksmbd: transport_ipc: validate payload size before reading handle
handle_response() dereferences the payload as a 4-byte handle without
verifying that the declared payload size is at least 4 bytes. A malformed
or truncated message from ksmbd.mountd can lead to a 4-byte read past the
declared payload size. Validate the size before dereferencing.
This is a minimal fix to guard the initial handle read. |
| In the Linux kernel, the following vulnerability has been resolved:
cxl/features: Add check for no entries in cxl_feature_info
cxl EDAC calls cxl_feature_info() to get the feature information and
if the hardware has no Features support, cxlfs may be passed in as
NULL.
[ 51.957498] BUG: kernel NULL pointer dereference, address: 0000000000000008
[ 51.965571] #PF: supervisor read access in kernel mode
[ 51.971559] #PF: error_code(0x0000) - not-present page
[ 51.977542] PGD 17e4f6067 P4D 0
[ 51.981384] Oops: Oops: 0000 [#1] SMP NOPTI
[ 51.986300] CPU: 49 UID: 0 PID: 3782 Comm: systemd-udevd Not tainted 6.17.0dj
test+ #64 PREEMPT(voluntary)
[ 51.997355] Hardware name: <removed>
[ 52.009790] RIP: 0010:cxl_feature_info+0xa/0x80 [cxl_core]
Add a check for cxlfs before dereferencing it and return -EOPNOTSUPP if
there is no cxlfs created due to no hardware support. |
| In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: f_ncm: Refactor bind path to use __free()
After an bind/unbind cycle, the ncm->notify_req is left stale. If a
subsequent bind fails, the unified error label attempts to free this
stale request, leading to a NULL pointer dereference when accessing
ep->ops->free_request.
Refactor the error handling in the bind path to use the __free()
automatic cleanup mechanism.
Unable to handle kernel NULL pointer dereference at virtual address 0000000000000020
Call trace:
usb_ep_free_request+0x2c/0xec
ncm_bind+0x39c/0x3dc
usb_add_function+0xcc/0x1f0
configfs_composite_bind+0x468/0x588
gadget_bind_driver+0x104/0x270
really_probe+0x190/0x374
__driver_probe_device+0xa0/0x12c
driver_probe_device+0x3c/0x218
__device_attach_driver+0x14c/0x188
bus_for_each_drv+0x10c/0x168
__device_attach+0xfc/0x198
device_initial_probe+0x14/0x24
bus_probe_device+0x94/0x11c
device_add+0x268/0x48c
usb_add_gadget+0x198/0x28c
dwc3_gadget_init+0x700/0x858
__dwc3_set_mode+0x3cc/0x664
process_scheduled_works+0x1d8/0x488
worker_thread+0x244/0x334
kthread+0x114/0x1bc
ret_from_fork+0x10/0x20 |
| In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: f_ecm: Refactor bind path to use __free()
After an bind/unbind cycle, the ecm->notify_req is left stale. If a
subsequent bind fails, the unified error label attempts to free this
stale request, leading to a NULL pointer dereference when accessing
ep->ops->free_request.
Refactor the error handling in the bind path to use the __free()
automatic cleanup mechanism. |
